Always wear rubber gloves and safety goggles

Keep product out of reach of children!

*Highly important* – headlights must be done in the shade direct sunlight will altar results

Step 1

Using the round or rectangular disc, apply an even amount of Part A and wipe lens clean to remove contamination. It may take a few applications, depending on how distorted the lens is, then wipe clean with lint free towel. Chrysler /Jeep vehicles may take a second step of cleaning to remove all contamination.

Step 2

Using the lint free towel, apply Part B to clarify the lens. The may appear to cloud the lens a bit. Don't worry this is normal. Wipe clean with lint free towel.

Step 3

Using black foam brush, drizzle a little of Part B on the tip and dunk the brush into Part C just enough to wet the tip of the foam brush. Apply evenly going north to south for best results. Do not swipe side ways or the product may run. Make sure you secure the cap on Part C or it could ruin if exposed to air continuously.

Let product dry for roughly 45 minutes before driving. You can turn the lights on to speed up the time by ½.

Also visit other Appearance Plus web sites:

www.appearance-plus.com
www.getcarcrazy.com
www.thedetailpros.com
www.teflonpaintsealant.com